ATTO Technology 3400 operation manual Ethernet and Telnet configuration commands

Page 20

7.1 Ethernet and Telnet configuration commands

Configure the ATTO FibreCenter 3400 using a Telnet session over the Ethernet port. The commands in this section configure or provide information about the Ethernet port and the Telnet session.

Default Router

Sets a new default router address for the Telnet server. Set the default router within the subnet as defined by the subnet mask and IP Address.

Limit: 0-255	Default: 0.0.0.0
Action: set•RACK •000•Default•Router•[n.n.n.n]	Information: get•RACK •000•Default•Router
reset•rack•000 or power cycle

Echo
Sets the Telnet command echo mode.
Limits: [onoff]
Action: set•RACK •000•Echo•[onoff]	Information: get•RACK •000•Echo
reset•rack•000 or power cycle


Factory Defaults
The Telnet parameters are set to their factory default values.
Action: set•RACK •000•Factory•Defaults	Information: none
reset•rack•000 or power cycle

Idle Timeout

Sets time period in seconds after which, if there is no action on the Telnet port, the Telnet session is shut down.

	Default: 60 minutes
Action: set•RACK •000•Idle•Timeout•[n]	Information: get•RACK •000•Idle•Timeout•[n]
reset•rack•000 or power cycle

IP Address
Sets a new IP address which will be used after next reset.
Limit: 0-255	Default: 192.168.1.1
Action: set•RACK •000•IP•address•[n.n.n.n]	Information: get•RACK •000• IP•Address
reset•rack•000 or power cycle

Security Traps
Sets the Telnet security level
	Default: 3
Action: set•Security•Traps•[n]	Information: get•RACK •000•Security•Traps
reset•rack•000 or power cycle

Subnet Mask
Sets a new subnet mask which will be used after next reset.
Limit: 0-255	Default: 255.255.255.0
Action: set•RACK •000•Subnet•Mask•[n.n.n.n]	Information: get•RACK •000•Subnet•Mask
reset•rack•000 or power cycle

Telnet
Ends the current Telnet session and opens another
Action: Telnet	Information: none

Telnet Status

Returns the Telnet status. The format will be determined in the future.

15 ATTO FibreCenter 3400 Installation and Operation Manual

Image 20

Contents Atto FibreCenter Secure Data Path Application Page Page Contents Configuration commands Term Definition Fibre Channel is a key technology for storageGlossary LED Atto FibreCenter supports diverse SAN needs Quick start instructionsZone Port Atto FibreCenter 3400 characteristics SpecificationsFeatures Local and network managementSecure Data Path Applicationv Setting up the FC Rack System Installing a power module Removing a power moduleTo change the password Setting up the Atto FibreCenterInstalling the FibreCenter Connecting Fibre Channel ports Cable length Cable type Cable size ConnectorRemoving the FibreCenter CablingZone 2 and Zone Configuring the Atto FibreCenterData transfer when setting up zones Invalid Switching Patterns Hub portsCommand Line Interface use and guidance CLI command conventionsExplanation Symbol IndicatesTelnet session Screen Ethernet and Telnet configuration commands Version Diagnostic commandsStatus Configuration commands Switch model Setup commandLinux Kernel Update Flash File System FFS UpdateType reboot and hit Enter at the bash# prompt Updating firmwareCondition TroubleshootingIf LED is illuminated If LED is not illuminated Index Command Line Interface Command Default ExampleEuropean Standards Declaration of Conformity Appendix a Standards and compliancesCanadian Standards Appendix B Contact Atto Technology, Inc