ATTO Technology 3400 operation manual Zone Port

Page 9

Exhibit 2-2 Dual-zone configuration (Zone 2 and Zone 3). Each zone is independent of the other, and so may be configured to run at different or the same speed: 1 Gigabit or 2 Gigabit. Ports 2, 3 and 4 may access port 1, but only one at a time, under control of the Command Line Interface Setup and Switch commands. Ports 6, 7 and 8 may access port 5, but only one at a time under control of the Setup and Switch commands.

Zone 2

Zone 3

Port 1

Port 2

Port 3

Port 4

Port 5

Port 6

Port 7

Port 8

Disk array	Host	Host	Host
Disk array

Disk array	Host	Host	Host
Disk array

Secure Data Path Applicationv 4

Image 9

Contents Atto FibreCenter Secure Data Path Application Page Page Contents Configuration commands Fibre Channel is a key technology for storage GlossaryTerm Definition LED Quick start instructions Atto FibreCenter supports diverse SAN needsZone Port Specifications Atto FibreCenter 3400 characteristicsFeatures Local and network managementSecure Data Path Applicationv Setting up the FC Rack System Removing a power module Installing a power moduleSetting up the Atto FibreCenter Installing the FibreCenterTo change the password Cable length Cable type Cable size Connector Connecting Fibre Channel portsRemoving the FibreCenter CablingConfiguring the Atto FibreCenter Data transfer when setting up zonesZone 2 and Zone Hub ports Invalid Switching PatternsCLI command conventions Command Line Interface use and guidanceSymbol Indicates Telnet session ScreenExplanation Ethernet and Telnet configuration commands Diagnostic commands StatusVersion Configuration commands Setup command Switch modelFlash File System FFS Update Linux Kernel UpdateType reboot and hit Enter at the bash# prompt Updating firmwareTroubleshooting If LED is illuminated If LED is not illuminatedCondition Command Default Example Index Command Line InterfaceAppendix a Standards and compliances Canadian StandardsEuropean Standards Declaration of Conformity Appendix B Contact Atto Technology, Inc