Removing Cover

RAID Rack with Port Multiplier Compatibility

Note: When configured as a set of individual drives, the Port Multiplier will only work with a Port Multiplier aware host. Identify your host controller and check with its hardware manufacturer if you are unsure. Addonics offers several Port Multiplier capable host adapters.

Loosen the 3 screws at the back of the towerusing a Philips screwdriver by turning counter-clockwise. Separate the metal casing of the tower from the housing by liftingup the casing

as shown in the drawing.

2.5" Drive Installation

Step 1

Open the door on the front of the RAID Tower Mini to reveal the Snap-In Double Drive.

Step 2

Gently push the silver button on the Snap-In

Double drive's door to open it.

Step 3

Push a 2.5" SATA drive into the bay, label side up, with the SATA connectors toward the rear. It should give little resistance, DO NOT force the drive.

Step 4

Once the drive has been pushed into the bay as far as it will go, close the door over it until the door snaps in place.

3.5" Drive Installation

Step 1

Slide the storage device into the embedded mounting bracket.

Step 2

Using 3.5” SATA Hard Disk Drives Connect the

internal SATA data cable to the data port of theHard Disk hard drive then connect the 15-pin SATA power

connector to the powerport on the hard drive. The Snap-In Double Drive is connected to Ports 0 and 1 on the HPM-XU Port Multiplier. Connect the top 3.5" drive to Port 2, the middle drive to port 3, and the bottom drive to Port 4.

Step 3

Secure the hard disk by using screws provided. Repeat the above procedure for additional hard drives.

www.addonics.com

Technical Support (M-F 8:30am - 6:00pm PST)

Phone: 408-453-6212

Email: www.addonics.com/support/query/