GE JVM1790 C5. MOUNT THE OVEN continued, C6. INSTALLING THE CHARCOAL FILTER, Screws Side Screw

Installation Instructions

C5. MOUNT THE OVEN (continued)

5Insert 2 self-aligning screws (1⁄4”-28 x 31⁄4”) through outer top cabinet holes. Turn two full turns on each screw.

6 Tighten center screw (1⁄4”-28 x 25⁄8”) completely.

7Tighten the outer two screws to the top of the oven. (While tightening screws, hold the oven in place against the wall and the top cabinet.)

8Install grease filters. See the Owner’s Manual packed with the oven.

C6. INSTALLING THE

CHARCOAL FILTER

1Remove 2 screws on top of oven, just above the grille panel, using a Phillips screwdriver. Remove one screw on the left side.

2Open the door.

3Remove the grille.

Screws

Side

Screw

4Insert the filter into the oven as shown, maneuvering it behind the plastic grille until it fits squarely into place. It will rest at an angle behind the plastic grille on two side support tabs and in front of the right rear tab. When properly installed, the wire mesh of the filter should be visible from the front.

5Replace the grille and the 2 top screws.

6Close the door and replace left side screw.

Insert mesh-side down

22