Installation Instructions
To use toggle bolts:
Spacing for Toggles More
Than Wall Thickness
Mounting | Toggle Wings | |
Toggle | ||
Plate | ||
Bolt | ||
|
Wall
Bolt End
3Place the mounting plate against the wall and insert the toggle wings into the holes in the wall to mount the plate.
NOTE: Before tightening toggle bolts and wood screw, make sure the tabs on the mounting plate touch the bottom of the cabinet when pushed flush against the wall and that the plate is properly centered under the cabinet.
CAUTION: Be careful to avoid pinching fingers between the back of the mounting plate and the wall.
4Tighten all bolts. Pull the plate away from the wall to help tighten the bolts.
B3. USE TOP CABINET TEMPLATE FOR PREPARATION OF TOP CABINET
You need to drill holes for the top support screws and a hole large enough for the power cord to fit through.
•Read the instructions on the TOP CABINET TEMPLATE.
•Tape it underneath the top cabinet.
•Drill the holes, following the instructions on the
TOP CABINET TEMPLATE.
CAUTION: Wear safety goggles when drilling holes in the cabinet bottom.
B4. ADAPTING BLOWER FOR OUTSIDE BACK EXHAUST
1Remove the three screws that hold the blower plate to the oven. Slide blower plate from under its retaining flange. Remove and save the screw that holds blower motor to oven.
Retaining |
|
Flange | Blower Plate |
| |
| Blower Motor |
| Screw |
2Carefully pull out the blower unit. The wires will extend far enough to allow you to adjust the blower unit.
BEFORE: Fan Blade |
| End B |
Openings Facing Up |
| |
|
| |
|
|
|
End A
3Rotate blower unit counterclockwise 180°.
Before Rotation | After Rotation |
Back of
OvenBack of
Oven
4Gently remove the wires from the grooves. Reroute the wires through grooves on other side of the blower unit.
Before Rerouting | After Rerouting |
Wires Routed Through Right Side | Wires Routed Through Left Side |
16
