GE JVM1790 Installation Instructions, Place the blower unit back into the opening

Installation Instructions

5Roll the blower unit 90° so that fan blade openings are facing out the back of the oven.

Before Rolling After Rolling

Back of	Back of
Oven	Oven

6Locate the two “knockout” plates, on the rear oven panel, near the top of the oven.

Using tin snips, carefully cut the web area from the two holes side-by-side (that secure the knockouts to the oven). Cut all four webs on both rear knockouts; this will allow the ventilation fan airflow to exhaust out the rear of the oven.

CAUTION: Be sure to trim the sharp edges from the openings after removing the knockout plates.

Oven Rear Panel

Snip all 4 webs on each knockout panel and remove

8Replace the blower plate in the same position as before with the screws.

Blower Plate Screws

Blower Plate

Back of Oven

9Insert the tabs on each side of the damper into the holes at the inside rear of the adaptor.

Exhaust

Adaptor

10Attach the exhaust adaptor to the rear of the oven by sliding it into the guides at the top center of the back of the oven.

the metal knockouts for rear airflow.

7Place the blower unit back into the opening.

AFTER: Fan	End A
Blade Openings
Facing Back
End B

Exhaust Adaptor

Slide exhaust adaptor into guides on oven rear.

Damper (hinge side up)

Back of Oven

Screws

Locking

Tabs

Guides

CAUTION: Do not pull or stretch the blower unit wiring. Make sure the wires are not pinched.

NOTE: The blower unit exhaust openings should match exhaust openings on rear of oven.

Push in securely until it is in the lower locking tabs. Take care to assure the damper hinge is installed so that it is at the top and that the damper swings freely.

11Secure the exhaust adaptor to the oven with the two bronze metal screws provided.

17