GE JVM1790 A4. MOUNT THE OVEN, A3. ASSEMBLE AND INSTALL ADAPTOR, IMPORTANT If filler blocks are

Installation Instructions

A2. USE TOP CABINET TEMPLATE FOR PREPARATION OF TOP CABINET

You need to drill holes for the top support screws, a hole large enough for the power cord to fit through, and a cutout large enough for the exhaust adaptor.

•Read the instructions on the TOP CABINET TEMPLATE.

•Tape it underneath the top cabinet.

•Drill the holes, following the instructions on the

TOP CABINET TEMPLATE.

A4. MOUNT THE OVEN

FOR EASIER INSTALLATION AND PERSONAL SAFETY, WE RECOMMEND THAT TWO PEOPLE

INSTALL THIS OVEN.

IMPORTANT: Do not grip or use handle during installation.

NOTE: If your cabinet is metal, use the nylon grommet around the power cord hole to prevent cutting of the cord.

NOTE: We recommend using filler blocks if the cabinet front hangs below the cabinet bottom shelf.

IMPORTANT: If filler blocks are

not used, case damage may occur from overtightening screws.

CAUTION: Wear safety goggles when drilling holes in the cabinet bottom.

A3. ASSEMBLE AND

INSTALL ADAPTOR

Damper

Exhaust

Adaptor

Blower Plate

Back of

Oven

1 Place the oven in its upright position, with the top

of the unit facing up.

NOTE: When mounting the oven, thread power cord through hole in bottom of top cabinet. Keep it tight throughout Steps 1–3.

Do not pinch cord or lift oven by pulling cord.

2Rotate front of oven up against cabinet bottom.

1

Lift oven, tilt it forward, and hook slots at back bottom edge onto four lower tabs of mounting plate.

2	Insert the tabs on each side of the damper into the
	holes at the inside rear of the adaptor.
3	Attach the exhaust adaptor to the blower plate with
	the two bronze metal screws provided.
	Make sure that the damper pivots easily before
	mounting oven.
	You will need to make adjustments to assure proper
	alignment with your house exhaust duct after the
	oven is installed.

3Insert a self-aligning screw through top center cabinet hole. Temporarily secure the oven by turning the screw at least two full turns after the threads have engaged. (It will be completely tightened later.) Be sure to keep power cord tight. Be careful not to pinch the cord, especially when mounting flush to bottom of cabinet.

13