Installation Instructions
C3. ADAPTING BLOWER FOR RECIRCULATION
NOTE: The exhaust adaptor with damper is not needed for recirculating models. You may want to save them for possible future use.
1Remove and save screws that hold blower plate to the oven.
Blower Plate Screws
Back of
Oven
2Slide the blower plate from under its retaining flange and lift it off. Remove and save screw that holds the blower motor to oven.
Retaining
Flange
Blower Plate
Blower Motor
Screw
3Carefully pull out the blower unit. The wires will extend far enough to allow you to adjust the blower unit.
4Roll the blower unit 90° so that fan blade openings are facing toward the front of the oven.
BEFORE: Fan Blade
Openings Facing Up
Roll
AFTER: Fan Blade
Openings Facing
Forward
NOTE: Make sure wires remain routed in the grooves of the motor frame.
20