How to connect a plug

This apparatus is fitted with an approved 13 Amp plug. To change a fuse in this type of plug proceed as follows:

¥Remove fuse cover and fuse.

¥Fix new fuse which should be a BS1362 5A, A.S.T.A. or BSI approved type.

¥Refit the fuse cover.

If the fitted plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place.

If the mains plug contains a fuse, this should have a value of 5A. If a plug without a fuse is used, the fuse at the dis- tribution board should not be greater than 5A.

Note: The severed plug must be disposed to avoid a possible shock hazard should it be inserted

into a 13A socket elsewhere.

The wires in the mains lead are coloured in accor- dance with the following code:

BLUE — "NEUTRAL" ("N") and BROWN — "LIVE" ("L").

As these colours may not correspond with the colour markings identifying the terminals in your plug, proceed as follows:

¥The BLUE wire must be connected to the terminal which is marked with the letter "N" or coloured BLACK.

¥The BROWN wire must be connected to the terminal which is marked with the letter "L" or coloured RED.

¥Do not connect either wires to the earth terminal in the plug which is marked by the letter "E" or by the safety earth symbol or coloured green or green-and-yellow.

Before replacing the plug cover, make certain that the cordgrip is clamped over the sheath of the lead — not simply over the two wires.

Recording and playback of material may require consent. See Copyright Act 1956 and The Performer s Protection Acts 1958 to 1972.

This product complies with the radio interference requirements of the European Union. Ce matériel satisfait aux impératifs de brouillage radio de la Communauté Européenne.

Este aparato satisface las normas relativas a la interferencia radioeléctrica de la

Comunidad Europea.

Dieses Produkt entspricht den Funkentstörvorschriften der Europäischen Union.