BenQ ESG-103 manual FCC Warning

Page 2

FCC Warning

This equipment has been tested and found to comply with the limits for Class A & Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a residential environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with this user's guide, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

CE Mark Warning

This device complies with requirements of EN50081-1 and EN50082-1 under the scope of EMC Directive EEC.

Trademarks

Copyright ©2002 BenQ Corporation.

Contents subject to change without prior notice. BenQ is a registered trade- mark of BenQ Corporation. All other trademarks belong to their respective proprietors.

Copyright Statement

No part of this publication may be reproduced in any form or by any means or used to make any derivative such as translation, transformation, or adapta- tion without permission from BenQ Corporation.

Image 2
Contents Broadband Router ESG-103 FCC Warning Table of Contents Table of Contents Being a router between two Ethernet interfaces Key FeaturesProduct Introduction Virtual Server Three ways to acquire WANs IP addressAct as a Dhcp server in its LAN side Web ManagementFirmware Upgrade Packing ListHardware Installation Back Panel Check the components you needConnecting PC to your ESG-103 Connect ESG-103 to your Adsl / Cable ModemState Indication Power onLED Indication Hardware Installation Configuration Quick Installation Wizard WAN ParametersPPPoE Parameters Remote Control Parameters LAN ParametersStatus InformationStatistics Advanced Setting DNS SetupDhcp Setup Dhcp Clone MAC AddressDhcp Server Parameters 3 NAT/DMZ Setup Table of fixed host entriesTable of current virtual server entries Service Name Name this service in 10 characters Dynamic NATStatic NAT Routing Table RIP SetupRIP Parameters Backup Dial Line Netmask Address Network maskAdmin Password Save SettingPower of ESG-103 before all progresses completed Reboot SystemUpdate Firmware Load Default Setting Appendix a Specufication Dhcp setting Appendix B TCP/IP Configuration for Windows 98/Me/2000Fixed IP setting Iii. Choose Disable DNS in the DNS Configuration tabAppendix C TCP/IP Configuration for Windows XP Appendix D Remove the Proxy Server in Web Browser Uncheck the box Use a proxy server under the Proxy server Memo Memo