BenQ ESG-103 manual Appendix a Specufication

Page 29

Chapter 4 Appendix

Appendix A:

Specufication

Ports

•1 x 10/100 Base-TX Fast Ethernet Wan port

•4 x 10/100 Base-TX Fast Ethernet switch ports

Operation Environment

•Ambient Temperature: 0°C - 40°C

•Relative Humidity: 5%-95%

Power

• 110V AC or 220AC10%, 47-63Hz

Dimension

• 172mm X 130mm X 26mm

Weight

• 305 g

Compliance

•FCC, CE, CCIB*

•UL/CSA, VCCI, C-Tick*

•(BSMI)

Chapter 4 Appendix - 25

Image 29

Contents Broadband Router ESG-103 FCC Warning Table of Contents Table of Contents Being a router between two Ethernet interfaces Key FeaturesProduct Introduction Act as a Dhcp server in its LAN side Three ways to acquire WANs IP addressVirtual Server Web ManagementPacking List Firmware UpgradeBack Panel Check the components you need Hardware InstallationConnect ESG-103 to your Adsl / Cable Modem Connecting PC to your ESG-103State Indication Power onLED Indication Hardware Installation Configuration WAN Parameters Quick Installation WizardPPPoE Parameters LAN Parameters Remote Control ParametersStatus InformationStatistics DNS Setup Advanced SettingDhcp Clone MAC Address Dhcp SetupDhcp Server Parameters Table of fixed host entries 3 NAT/DMZ SetupTable of current virtual server entries Dynamic NAT Service Name Name this service in 10 charactersStatic NAT Routing Table RIP SetupRIP Parameters Netmask Address Network mask Backup Dial LineSave Setting Admin PasswordPower of ESG-103 before all progresses completed Reboot SystemUpdate Firmware Load Default Setting Appendix a Specufication Fixed IP setting Appendix B TCP/IP Configuration for Windows 98/Me/2000Dhcp setting Iii. Choose Disable DNS in the DNS Configuration tabAppendix C TCP/IP Configuration for Windows XP Appendix D Remove the Proxy Server in Web Browser Uncheck the box Use a proxy server under the Proxy server Memo Memo