BenQ ESG-103 manual Appendix C TCP/IP Configuration for Windows XP

Page 31

Appendix C:

TCP/IP Configuration for Windows XP

1.Double click Start icon, and choose the settings, then click Control Panel.

2.Double click the Network icon. See the Configuration tab, and select the TCP/IP line that has been associated to your network card.

3.Click Properties button to set the TCP/IP protocol for your ESG-103 gateway.

4.Please choose one setting method from a. Fixed IP address or b. DHCP.

a. Fixed IP setting:

i. Select Specify an IP address in the IP address tab. The default IP address for ESG-103 is 192.168.1.1. According to the data, please fill in 192.168.1. X (X is a number between 1 to 253) for IP address field and 255.255.255.0 for Subnet Mask filed.

ii.In the Gateway tab add the IP address of ESG-103 (default IP is 192.168.1.1) in the New Gateway field and click Add button.

iii.In the DNS configuration tab, please choose Enable DNS, fill in the Host name, then add DNS values which are provided by your ISP into DNS Server Search Order and click Add button.

iv.Restart your computer.

b. DHCP setting:

i. Select Obtain an IP address automatically in the IP address tab.

ii.Do not need to input values in Gateway tab.

iii.Choose Disable DNS in the DNS Configuration tab.

iv.Restart your computer.

Chapter 4 Appendix - 27

Image 31
Contents Broadband Router ESG-103 FCC Warning Table of Contents Table of Contents Product Introduction Key FeaturesBeing a router between two Ethernet interfaces Web Management Three ways to acquire WANs IP addressAct as a Dhcp server in its LAN side Virtual ServerPacking List Firmware UpgradeBack Panel Check the components you need Hardware InstallationConnect ESG-103 to your Adsl / Cable Modem Connecting PC to your ESG-103LED Indication Power onState Indication Hardware Installation Configuration WAN Parameters Quick Installation WizardPPPoE Parameters LAN Parameters Remote Control ParametersStatistics InformationStatus DNS Setup Advanced SettingDhcp Clone MAC Address Dhcp SetupDhcp Server Parameters Table of fixed host entries 3 NAT/DMZ SetupTable of current virtual server entries Dynamic NAT Service Name Name this service in 10 charactersStatic NAT RIP Parameters RIP SetupRouting Table Netmask Address Network mask Backup Dial LineSave Setting Admin PasswordUpdate Firmware Reboot SystemPower of ESG-103 before all progresses completed Load Default Setting Appendix a Specufication Iii. Choose Disable DNS in the DNS Configuration tab Appendix B TCP/IP Configuration for Windows 98/Me/2000Fixed IP setting Dhcp settingAppendix C TCP/IP Configuration for Windows XP Appendix D Remove the Proxy Server in Web Browser Uncheck the box Use a proxy server under the Proxy server Memo Memo