Tripp Lite UPS SNMPWEBCARD instruction manual Managing the UPS

Page 7

Managing the UPS

e. Save settings. The card will then reboot; depending on the selected configuration settings, it will take 2-5 minutes for the card to become initialized.*

5.Prepare SNMPWEBCARD for Operation

a. Remove the cable connecting the SNMPWEBCARD to the computer.

b. Test network configuration by pinging the IP address given to the SNMPWEBCARD.

c. If test is successful, replace the UPS accessory slot plate and secure it with screws to hold the SNMPWEBCARD firmly in position.

* Or configure other SNMPWEBCARD settings as explained in this chapter.

Image 7

Contents UPS Snmpwebcard Table of Contents Snmpwebcard System Requirements Chapter IntroductionItem Description Snmpwebcard DetailsPackage Contents Selecting an IP Address Chapter ConfigurationTerminal Mode Configuration Setting ValueManaging the UPS Snmp ChapterNavigating the Snmpwebcard Web Pages Chapter Browser InterfaceEstablishing a Connection To Log On to the UPS AdapterDevice Information Menu BarDevice Summary Action Menu Alarm StatusAvailable Actions Loads Screen LoadsDevice Settings MenusContacts EventsContact Settings Menu Network Configuring Snmp Trap DestinationsSnmp Menu TCP/IP MenuTelnet Menu Web Menu10 Set Date/Time System12 Event Logs Event LogsProblem Solution Unable to perform Snmp set operations Chapter TroubleshootingProblem IP Address of the Snmpwebcard is unknown Solution Problem Unable to perform Snmp get operations SolutionEnvironmental Specifications Appendix a SpecificationsName Description PS/2 ConnectorPS/2 Connector Pins Serial Port Adapter Card