1111 W. 35th Street
Chicago, IL 60609 USA
Customer Support: (773)
www.tripplite.com
Owner’s Manual
APS/PV Remote
for PowerVerter APS and PowerVerter Plus Models
ESPAÑOL: p. 3
The APS/PV Remote allows you to monitor and control at a distance many of the functions of a Tripp Lite PowerVerter Plus or PowerVerter APS model featuring a RJ11 Remote Port.
Installation
LabelFor Use with a PowerVerter APS: Affix the label marked "APS Remote" to the front of the Remote so that the holes in the label align with the Remote's LEDs and switch.
For Use with a PowerVerter Plus: Affix the label marked "PV Remote" to the front of the Remote so that the holes in the label align with the Remote's LEDs and switch.
Cable: Insert one end of the 50' Remote Cable into the Remote Port on the front of your PowerVerter. Insert the other end into the RJ11 port on the bottom of the Remote.
Mounting: Using two to four screws appropriate to your mounting surface*, attach the Remote securely so that the LEDs can be clearly seen.
* Screws must be provided by the user.
Operation
PV Remote
1 | 2 | 3 |
APS Remote
1 | 4 | 5 | 6 | 7 |
These three lights show the approximate charge of your connected batteries.
| LEDs Illuminated | Approximate Charge | |
Green | 96% | - Full |
Green & yellow | 81% | - 95% |
Yellow | 61% | - 80% |
Yellow & red | 41% | - 60% |
Red | 21% | - 40% |
All | three |
| lights | off | 1% - 20% |
|
|
|
|
|
|
|
| |||||||||||||||||||||||
Flashing |
| red |
|
|
|
|
|
|
|
|
|
|
|
| 0% (Inverter shutdown) | |||||||||||||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
All three lights flash slowly |
|
|
| Excessive | discharge | |||||||||||||||||||||||||||||||
All | three |
| lights | flash quickly |
|
|
| Overcharge |
| or charger fault | ||||||||||||||||||||||||||
Copyright © 2000 Tripp Lite. All rights reserved. PowerVerter® is a registered trademark of Tripp Lite | 1 |