Tripp Lite SMART3000RMOD2U owner manual Basic Operation continued, Other UPS Features Rear Panel

Basic Operation (continued)

Other UPS Features (Rear Panel)

	AC Receptacles: The SMART3000RMOD2U UPS features six 15-amp outlets and one 30-amp outlet. These output receptacles
	provide your connected equipment with AC line power during normal operation and battery power during blackouts and brownouts.
	The UPS protects equipment connected to these receptacles against damaging surges and line noise. With the serial or USB
	connection to your UPS, you can also remotely reboot connected equipment by turning the receptacles OFF and ON using Tripp
15 amp/120V	Lite’s PowerAlert software and SNMPWEBCARD.
NEMA 5-15/20R

30amp/120V NEMA L5-30R

Communications Ports (USB and RS-232):These ports connect your UPS to a workstation or server. Use with Tripp Lite’s PowerAlert software and included cables to enable your computer to automatically save open files and shut down equipment during a blackout. Also use PowerAlert software to monitor a wide variety of AC line power and UPS operating conditions. Consult your PowerAlert software manual or contact Tripp Lite Customer Support for more information.

EPO (Emergency Power Off) Port: Your UPS features a EPO port that may be used to connect the UPS to a contact closure switch to enable emergency inverter shutdown. See “Optional Installation”.

Battery Configuration Port: This port enables the UPS to automatically 1) detect how many external Tripp Lite battery packs (that support this feature) are attached to the UPS and 2) estimate the remaining battery run time. The SMART3000RMOD2U detects up to 4 external Tripp Lite battery packs.

Accessory Slot: Remove the small cover panel from this slot to install optional accessories (such as Tripp Lite’s Relay I/O Card) to remotely monitor and control your UPS. Refer to your accessory’s manual for installation instructions. Contact Tripp Lite Customer Support at (773) 869-1234 for more information, including a list of available SNMP, network management and connectivity products.

External Battery Connector: Use to connect optional Tripp Lite external battery packs for additional runtime. Small sparks may result during battery connection; this is normal. Do not connect or disconnect battery packs while the UPS is running on battery power (the “ON BATTERY” LED will be lit on the control panel).

Output Breakers: Your UPS features one or more breakers that protect your UPS from output overload. If one or more breakers trip, remove some of the load on the circuit(s), then reset them by pressing the breaker switch(es) in.

Ground Screw: Use this to connect any equipment that requires a chassis ground.

11