Tripp Lite OmniPro500 Quick Installation, Optional Installation, Set your UPS’s OFF on Switch

Quick Installation

1

2

Plug your UPS into an electrical outlet.

Plug essential equip- ment such as your computer, monitor and modem into battery- supported outlets.

Plug other equipment into surge-only outlets.*

*Separate battery-supported/surge and surge- only outlets are identified on the back of your UPS. Your UPS is designed to support only computer equipment. You will overload your UPS if you connect household appliances, laser printers or surge suppressors to the battery- supported outlets.

Optional Installation**

Using telephone cords, connect your wall jack to the UPS jack marked “LINE” (or “IN”). Connect your equipment

to the UPS jack marked “EQUIP” (or “OUT”).

**Phone line connections are optional. Your UPS will function properly without these connections. Make sure the equipment you connect to the UPS’s telephone jacks is also protected against damaging surges on the AC line.

3 Set your UPS’s “OFF – ON” Switch.***

•Set to “ON” when you are using connectedequipment.

•Set to “OFF” when you are not using connectedequipment.

(WARNING! When set to “OFF,” UPS will not provide battery backup during a blackout or brownout.)

***See Basic Operation section for the Switch Function, UPS Conditions and Setting Advantages.

3