SMART CAT5 SWITCH – 108/116
Input the DDC information of the monitor connected to the Smart CAT5 switch into the memories of all connected ROC/RICCs when first installing system.
To input the DDC information:
1.Disconnect the Video cable of all ROC/RICCs from the computers.
2.Press Shift twice to open the OSD.
3.Press F10. “Please wait” flashes a few times and disappears. The monitor’s DDC information is sent to all ROC/RICCs.
4.Reconnect the Video cable of all ROC/RICCs.
4.2.14.1 Updating the DDC information
Update the DDC information in any of the following circumstances:
When replacing the monitor connected to Smart CAT5 Switch
When adding a new ROC/RICC to the system
When reconnecting an existing ROC/RICC that was temporarily used in a different system
To update the DDC information, repeat the steps as set out above.
25