Moxa Technologies NPort 5600 user manual Reverse Telnet Mode, Map CR-LF

NPort 5600 Series User’s Manual Configuring NPort Administrator

Reverse Telnet Mode

TCP alive check time

Setting	Factory Default	Necessity
0 to 99 min	0	Optional

Specifies the time slice for checking if the TCP connection is alive. If there is no response, NPort 5600 series will disconnect the original connection.

Inactivity time

Setting	Factory Default	Necessity
0 to 65535 ms	0	Optional
Idle time setting for auto-disconnection. 0 min. means it will never disconnect.
Local TCP port
Setting	Factory Default	Necessity
1 to 65535	4001	Optional

Each of NPort’s serial ports is mapped to a TCP port. To avoid conflicts with TCP ports, set port numbers to 4001 for port1, 4002 for port 2, etc. (like the default values).

Map <CR-LF>

Setting	Factory Default	Necessity
CR, LF, or CR-LF	CR-LF	Optional

If data received through NPort 5600’s Ethernet port is sent using the “enter” command, the data will be transmitted out the serial port with an added

1.“carriage return + line feed” if you select the <CR-LF> option

(i.e., the cursor will jump to the next line, and return to the first character of the line)

2.“carriage return” if you select the <CR> option

(i.e., the cursor will return to the first character of the line)

3.“line feed” if you select the <LF> option.

(i.e., the cursor will jump to the next line, but not mov horizontally)

5-27