Step 6. Install the SANsurfer Router Manager
Perform the following steps to install the SANsurfer iSCSI/FC Router Manager application from the QLogic website to a PC workstation:
1.Close all programs currently running.
2.Go to the QLogic download site: http://support.qlogic.com/support/drivers_software.aspx
3.Select the Intelligent Storage Routers icon.
4.Select iSR6140 in the product selection window and click Go.
5.Under the product name column, select the link to the SANsurfer Router Manager for your operating system.
6.Read the license agreement and click Agree.
7.Follow the system prompts to uncompress and install the application.
Step 7. Configure iSR6140 Management Port IP Address
Connect the router’s 10/100 Ethernet port to your workstation using a switch or hub. Alternatively you may connect your workstation directly to the router using an Ethernet crossover cable.
The iSR6140 management port’s default IP address is 10.0.0.1 subnet 255.0.0.0. Make sure the workstation connected to the iSR6140 router has Ethernet address 10.0.0.x, where x is other than 1 and subnet mask is 255.0.0.0.
From the workstation, open a command window and using a telnet session connect to iSR6140 using IP address 10.0.0.1. Login as “guest” and use the password “password." This will take you to a CLI prompt as shown in Figure 4.
Figure 4. QLogic Router Command Line Interface
Enter the CLI command admin start. The default password is “config.” Enter the set mgmt command at the QRouter (admin) #> prompt.
Select the mode. We recommend you use static address. Select Option 0 and enter the IP address, subnet information, and gateway, if applicable.
You will lose the connectivity of the telnet session at this time. If you want to continue using the CLI, restart the telnet session with the IP address you just assigned to the management port.
4