Installation Procedures
6. Installation of Ornament Panel
Install ornament panel on indoor unit
(1)Check whether indoor unit is horizontal with leveler or polythene pipe filled with water , and check that the dimension of the ceiling opening is correct. Take off the lever gauge before install the ornament panel.
(2)Fasten the screws to make the height difference between the two sides of indoor unit less than 5mm.
(3)First fix it with screws temporally.
(4)Fasten the two temporally fixing screws and other two, and tighten the four screws.
(5)Connect the wires of
(6)Connect the wire of signal.
(7)If no response of remote controller,check whether the wiring is correct,restart remote controller 10 seconds after shut off power supply.
Control box
Limits of panel board installation
(1)Install the panel board in the direction shown in the figure.
(2)The incorrect direction will result in water leakage, meanwhile swing and signal receiving are displayed that cannot be connected.
15
