SANbox 9000™ Series Chassis Replacement Guide
A
Observe Heartbeat LED
Observe the Heartbeat LED on the CPU blade. It should blink once per second.
If the Heartbeat LED is showing a different blink pattern, refer to the Installation Guide for diagnostic procedures or contact your authorized maintenance provider.
1 |
1. Heartbeat LED
Verify the POST Results
Open a Telnet session and enter the Show Blade command to display the diagnostic status for all blades. You can also use the Switch tab and Blade Info tab of the QuickTools interface.
telnet 10.0.0.1 |
|
|
|
|
|
| |
Switch Login: admin |
|
|
|
|
| ||
Password: password |
|
|
|
|
| ||
SANbox #>show blade |
|
|
|
|
| ||
Blade | Blade | Port | Admin | Oper | Fault | Temp | Voltage |
ID | Type | Range | State | State | Status | Status | Status |
IO0 | FC4G16 | Online | Online | None | Normal | Good | |
IO1 | FC4G16 | Online | Online | None | Normal | Good | |
IO2 | * | * | Online | NotInst | * | * | * |
IO3 | * | * | Online | NotInst | * | * | * |
IO4 | * | * | Online | NotInst | * | * | * |
IO5 | * | * | Online | NotInst | * | * | * |
IO6 | * | * | Online | NotInst | * | * | * |
IO7 | * | * | Online | NotInst | * | * | * |
+CPU0 | CPU | N/A | Online | Online | None | Normal | Good |
CPU1 | CPU | N/A | Online | Online | None | Normal | Good |
PS0 | PSFB | N/A | N/A | N/A | None | N/A | N/A |
PS1 | PSFB | N/A | N/A | N/A | None | N/A | N/A |
FAN0 | FANFB | N/A | N/A | N/A | None | N/A | N/A |
FAN1 | FANFB | N/A | N/A | N/A | None | N/A | N/A |
MP | MP | N/A | N/A | N/A | None | N/A | N/A |
Reinstall License Keys
The old license keys are not valid with the new chassis serial number. Visit www.QLogic.com (Support/Product Feature Activation/
License Key Activation Center/Replace License Keys) to obtain new license keys to replace those installed on the original chassis.
SANbox #> admin start
SANbox (admin) #> feature add
This feature upgrade does NOT require a switch reset. Do you want to continue with license upgrade procedure?
(y/n): [n] y
Log Msg: [day mon date hh:mm:ss.sss CST year] [C][8400.006B][Switch][Upgrading License for HyperStack(tm)capability]
Log Msg: [day mon date hh:mm:ss.sss CST year] [C][8400.0047][Switch][New licenses are being installed]
You will need the following information:
Original chassis serial number
New chassis serial number (Show Version command)
Your email address
With the new license keys, enter the Feature Add command to install license keys that were installed on the original chassis.
Copyright© 2007 QLogic Corporation. SANbox is a trademark of QLogic Corporation
8 |