Installing the CP-132UL Series Board
Step 1: Power off the PC.
WARNING
To avoid damaging your system and board, make sure your computer is turned off before installing any serial board.
| Step 2: Remove the PC’s cover. |
| Step 3: Remove the slot cover bracket if there is one. |
| Step 4: Plug the |
| PCI slot. |
| Step 5: Fasten the holding screw to fix the control board in place. |
| Step 6: Replace the system cover. |
| Step 7: Power on the PC. The BIOS will automatically set the IRQ and I/O address. |
|
|
NOTE | Moxa PCI and Universal PCI boards must be assigned unique IRQ and I/O addresses. Both |
| addresses are assigned automatically by the PCI BIOS. |
|
|
| Step 8: Proceed with the software installation discussed in the next chapter, “Software |
| Installation.” |