Schneider Electric 120, 230 VAC, 208 Display interface has a Site Wiring Fault message

Page 16

Problem and Possible Cause

Solution

The replace battery indicator is illuminated

The battery has a weak charge.

Allow the battery to recharge for at least four hours. Then, perform a self-test. If the problem persists after recharging, replace the battery.

The replacement battery is not properly	Ensure that the battery connector is securely connected.
connected.

The display interface has a Site Wiring Fault message

Wiring faults detected include missing ground, hot-neutral, polarity reversal, and overloaded neutral circuit.

If the UPS indicates a site wiring fault, have a qualified electrician inspect the building wiring. (Applicable for 120 V units only.)

Smart-UPS 750-3000 VA 120/208/230 Vac Rack-mount

Image 16

Contents Smart-UPSUPS Contents Smart-UPS Factory Warranty Safety OverviewProduct Description Product OverviewRear panels 750/1000/1500 VA 120750/1000/1500 VA 230 2200 VA 120Specifications InstallationEnvironmental Specifications Operating ConditionsOperation Rear Panel FeaturesConnect Equipment to the UPS Using the display interface Display InterfaceOverview Standard menusAdvanced menus Configuration UPS SettingsStart-up Settings General SettingsLow Battery Battery Replacement Audible AlarmBattery Self SettingMain Outlet Group and the Switched Outlet Group Using the Main Outlet Group and the Switched Outlet GroupNetwork Management Card Settings Emergency Power Off EPO OverviewNormally open contacts Normally closed contactsTroubleshooting UPS does not provide expected backup timeDisplay interface indicators flash sequentially UPS is emitting an audible beeping soundDisplay interface has a Site Wiring Fault message Service Service and SupportTransport the unit APC Worldwide Customer Support Smart-UPS Factory Warranty Limited Warranty990-3858 06/2010