Sun Microsystems SPARCserver 1000, 600MP series manual Verifying the Installation, Ok show-devs

2

2.2 Verifying the Installation

Refer to the Solaris 2.5 Handbook for SMCC Peripherals manual or your Solaris

documentation for detailed instructions for the following tasks.

1.Power on the system, and when the banner appears, press the Stop-A keys to interrupt the boot process and get to the ok prompt.

2.Use the show-devscommand to list the devices in the system.

You should see two lines (similar to the example below) in the display, specific to the SunSwift SBus Adapter:

ok show-devs

...

/iommu@f,e0000000/sbus@f,e0001000/SUNW,fas@0,8800000

/iommu@f,e0000000/sbus@f,e0001000/SUNW,hme@0,8c00000

...

•fas@0 identifies the adapter’s SCSI-2 device.

•hme@0 identifies the adapter’s Ethernet device.

Note – In the above example, the number 0 following fas@ and hme@ corresponds to the instance number of the SunSwift SBus Adapter installation. The numbers you see when listing the system devices may be different.

If you do not see these devices listed, check that the adapter is properly seated and reinstall the adapter, if necessary.

2-2 SunSwift SBus Adapter Installation and User’s Guide—December 1995