Sun Microsystems SPARCcenter 2000 manual Installing the Adapter, Performing the Installation

Installing the Adapter 2

This chapter tells you how to install the adapter in your system, verify that the adapter is correctly installed, and boot your system.

2.1 Performing the Installation

Note – Refer to your system installation or service manual (and the SCSI device installation manual, as necessary) for detailed instructions for the following tasks.

1.Power off your system, using the standard shutdown procedures described in Solaris 2.5 Handbook for SMCC Peripherals.

2.If you are replacing an SBus card with the SunSwift SBus Adapter, remove the old card now.

3.Install the SunSwift SBus Adapter in the selected SBus slot.

4.Attach the SCSI cable to the 68-pin SCSI connector on the adapter and to the SCSI device, if necessary.

5.Connect the Ethernet cable to the SunSwift SBus Adapter RJ-45 connector and to the hub.

Connect the new Ethernet cable if you are using two Ethernet interfaces.

2-1