■Ready to Remove status shows Not Ready in the ILOM interfaces.
TABLE 2-3 NEM LED Status
Service Action | OK LED (Power, Attention, | Status | |
LED | Required LED | and Connected) |
|
Color: Blue | Color: Yellow | Color: Green |
|
Location: Top | Location: Middle | Location: Bottom |
|
|
|
|
|
On | Off | Off | Ready to remove |
Off | On | Off | Service attention required |
Off | Off | Very slow blink | Standby |
Off | Off | Slow blink | Connecting links to blades |
Off | Off | On | Links connected to blades |
|
|
|
|
FIGURE 2-5 LEDs, Attention and Locator Buttons
The Attention button enables you to activate (if inserting) or prepare to remove (if removing) a NEM during a
The Locator button, when pressed momentarily, flashes a white light to assist in locating the module. You can also activate the Locator LED remotely by executing a command on the CMM.
Chapter 2 Hardware Installation and Removal | 19 |