Sun Microsystems 4000, 5000, 6000 manual Connecting the Power Cords

2

Bottom panel

Cable

Kick panel

Figure 2-3Routing Cables Under the Kick Panel

2.3Connecting the Power Cords

2.3.1Connecting the Enterprise 6000/5000 System Power Cord

1.Remove the rear screen and the kick panel.

See Section 2.2, “Removing and Replacing the Enterprise 6000/5000 Cabinet Rear Screen and Kick Panel.”

2.Route the AC power cord and external interface cables along the bottom panel of the cabinet and over the edge of the bottom panel.

See Figure 2-3. The cables should be between the bottom panel and the kick panel when you replace the kick panel.

3.Uncoil the AC power cord and plug it into a grounded wall outlet.

The outlet must be a 200-240 VAC 30A circuit, dedicated solely to the server cabinet, as described in the site preparation instructions in Chapter 1.

2-4 Ultra Enterprise 6000/5000/4000 Systems Installation Guide—November 1996