3
Note – If JumpStart automatic installation begins unintentionally, interrupt it by pressing
If JumpStart completes the installation incorrectly, you may need to reinstall
Solaris 2.x manually.
3.2 Enterprise 6000/5000 Cabinet Systems
3.2.1 Powering On the System
Note – It is advisable to connect an ASCII terminal to the system during installation. See Section 2.6, “Connecting an ASCII Terminal,” for terminal settings and connections.
Observe the yellow (middle) LED on the front panel. It should go off when boot completes. If it remains lit, observe the terminal screen for boot messages produced by the firmware diagnostic program during power on.
To power on the cabinet system:
1.Begin with a safety inspection of the system:
a.Turn the system key switch to (the Standby position). See Figure
Note – The standby position () does not turn off any
b.Turn the AC power sequencer power switch to Off.
The AC power sequencer is at the rear of the cabinet. See Figure
c.Verify that the cabinet AC power cord is plugged into a wall socket.
Ultra Enterprise 6000/5000/4000 Systems Installation |