Paradyne EAM2000-12 manual Installation

Page 1

Interface Module User Guide

EAM2000-12

12-Port E1 Access Multiplexer

CAUTION Net to Net Technologies strongly recommends the use of proper electrostatic discharge (ESD) precautions when handling this equipment.

INSTALLATION

1.Unpack and inspect the EAM2000-12.

If there is visible damage, do not attempt to connect the device; contact Customer Support at 1- 877-638-2638 (001-603-427-0600 for international customers) or Support@NetToNet.com.

2.Install the EAM2000-12 in an IP DSLAM chassis.

NOTE There must be a Multiplexer Uplink Module installed in the IP DSLAM chassis in order for Access Modules to operate.

All Access Multiplexer Modules for Net to Net Technologies' IP DSLAMs are hot swappable; installing or removing an Access Module while the chassis is powered up does not affect the operational status of other Access Modules within the chassis. The IPD12000 is a fourteen slot chassis; slots 1-12 are reserved for Access Modules (such as the EAM2000-12) and slots 13-14 are reserved for Multiplexer Uplink Modules (such as the MUM200-2). Access Modules may be placed in any order in slots 1-12. The IPD4000 is a five slot chassis; slots 1-4 are reserved for Access Modules and slot 5 is reserved for a Multiplexer Uplink Module.

a.Align the EAM2000-12 with the slot module guides of the chosen slot for installation (slot 1-12 on the IPD12000 or slot 1-4 on the IPD4000).

b.Slide the EAM2000-12 firmly into the chassis. DO NOT USE EXCESS FORCE.

c.Secure the EAM2000-12 by tightening the fastening screws on the module faceplate.

d.Verify that the PWR (Power) LED on the EAM2000-12 faceplate is illuminated.

210-0000036 rev03

Image 1
Contents EAM2000-12 InstallationAccessing EAM2000-12 data in a newly installed IP Dslam E1 RJ21 Connector Port PinoutOverview Management Password Administration Defaults Accessing EAM2000-12 data in a previously installed IP DslamManagement System Configuration Defaults EAM2000-12 Circuit ConfigurationEAM2000-12 Circuit Defaults EAM2000-12 Timeslot & Bandwidth OptionsHigh Density Binary 3 Default Cyclic Redundancy Check DefaultLocal Default Alternate Mark InversionAdditional Information LED IndicatorsThis Class a product complies with European Norm EN55022