CMA Dishmachines CMA-66 manual Scrap Tray Assembly and Overflow Chute Installation, Req’D

Getting Started

2.3.4. Scrap Tray Assembly and Overflow Chute Installation

The scrap tray assembly and overflow chute, which came packaged inside the machine, can easily be installed by executing the following steps: Figure 2.3.4 below illustrates the assembly as it would appear for a Left-to-Right machine – a Right-to- Left machine would simply be the mirror image.

Caution: For proper spacing, the

SSflat washer (item 2) must not be located between the head of the trusshead bolt and the inside of the machine.

Figure 2.2.4

ITEM	NO.	P/N		DESCRIPTION
NO.	REQ’D
1	7	00905.00	¼-20 X ½” Trusshead Bolt
2	11	00924.00	¼” SS Flat Washer
3	11	00912.00	¼-20 Nylon Lock Nut
4	1	13511.26	CMA-66P	Overflow Gasket
5	1	13511.06	CMA-66P	Overflow Chute (L-R)
		13511.16	CMA-66P	Overflow Chute (R-L)

ITEM	NO.	P/N	DESCRIPTION
NO.	REQ’D
			¼-20 X ½” Hex Head Bolt
6	4	00906.00
			Scrap Trap Holder
7	1	17579.00
			Scrap Trap Body Molded
8	1	01579.10
9	1	01579.20	Scrap Trap Drawer Molded

1.Remove the items from their packing and verify that all the pieces are present.

2.Attach the overflow chute with the five ¼-20 X ½” trusshead bolts, ¼” SS Flat Washers, and ¼-20 Nylon Lock Nuts provided.

3.Secure the scrap trap holder to the dishmachine using the four ¼-20 X ½” Hex Head Bolts, ¼” SS Flat Washers, and ¼-20 Nylon Lock Nuts provided.

4.Set the scrap trap body—with the scrap trap drawer inserted—into position on the scrap trap holder.

5.Attach the drain as specified in section 2.3.2 Plumbing.

MODEL CMA-66 Installation & Operation Manual Rev. 1.09 Page 8