4.2.4Log In
Log in with your assigned username and password. For SAM2000G configuration, you must log in as a superuser (general users have read only access). If your username and/or password are unknown, contact your System Administrator or Information Technology Manager for assistance.
Once you have logged in as a superuser, you will be able to make configuration changes to the SAM2000G, and any other interface modules installed in your IP DSLAM, as desired. For more detailed information regarding SAM2000G configuration via NMS, refer to Net to Net's NMS Management User Guide:
4.3Via Simple Network Management Protocol (SNMP)
NOTE The
4.3.1Establish a Connection With Your IP DSLAM
Establish a connection between your IP DSLAM and your PC, either directly (through the 10/100 Ethernet MGMT port on the MUM faceplate) or, if your DSLAM has been configured to allow inband management, across your local network. For direct connections, verify that the MGMT LNK LED on the MUM faceplate is illuminated.
4.3.2Launch Your MIB Browser
Launch a MIB browser program on your PC. If you have not yet downloaded the necessary MIBs to your PC or local network, you can obtain the Net to Net enterprise MIBs from ftp://ftp.nettonet.com/download/mibs and the supported portions of
Once the MIBs have been compiled, you will be able to make configuration changes to the SAM2000G, and any other interface modules installed in your IP DSLAM, as desired. For more detailed information regarding SAM2000G configuration via SNMP, refer to Net to Net's SNMP Management User Guide:
5.0BANDWIDTH AND DISTANCE
NOTE Parameters common to all interface module models are defined in the CLI, NMS and SNMP Management User Guides. Bandwidth, however, is specific to the