Installation, Connect the Shdsl Lines

2.0INSTALLATION

CAUTION Net to Net Technologies strongly recommends the use of proper electrostatic discharge (ESD) precautions when handling this equipment.

2.1Unpack and Inspect the SAM2000G

If there is visible damage, do not attempt to connect the device; contact Customer Support at 1-877- 638-2638 (1-603-427-0600 for international customers) or support@nettonet.com.

2.2Install the SAM2000G in an IP DSLAM Chassis

NOTE There must be a Multiplexer Uplink Module (MUM) installed in your IP DSLAM chassis in order for interface modules to operate.

Net to Net Technologies' IP DSLAM interface modules are hot swappable; installing or removing an interface module while the chassis is powered up does not affect the operational status of other interface modules within the chassis. The IPD12000 is a fourteen slot chassis; slots 1-12 are for interface modules such as the SAM2000G, slots 13 and 14 are reserved for MUMs. Interface modules may be placed in any order in slots 1-12. The IPD4000 is a five slot chassis; slots 1-4 are for interface modules, slot 5 is reserved for a MUM.

zAlign the SAM2000G with the module guides in the slot chosen for installation (slot 1-12 on the IPD12000 or slot 1-4 on the IPD4000).

zSlide the SAM2000G firmly into the chassis. DO NOT USE EXCESS FORCE.

zSecure the SAM2000G by tightening the fastening screws on the module faceplate.

zVerify that the PWR (Power) LED on the SAM2000G faceplate is illuminated.

2.3Connect the SHDSL Line(s)

Plug the SHDSL cable into the RJ21 port, of the chosen slot, on the back of your IP DSLAM. Verify your connections; the SHDSL LK LED for each connected port will illuminate solid or pulsing green. Link-up time for connections between the SAM2000G and remote SHDSL modems can vary from one to five minutes depending on the quality, gauge and distance of the copper cables. Default bandwidth for the SAM2000G is 272 kbps.

210-0000026 rev07