Quatech RS-232 user manual Hardware Configuration

Page 8

2 Hardware Configuration

The ESC(LP)-100 is automatically configured at boot time by the computer's BIOS or operating system. There are no switches or jumpers to set for installation. See Section 5.5 for instructions on how to use Windows Device Manager to view and change resource settings.

ESC(LP)-100 User's Manual

Image 8

Contents ESCLP-100 Warranty Information Iii Declaration of Conformity Enhanced Serial Adapter Identification Changing Resource Settings with Device ManagerBase Address and Interrupt Level IRQ Page General Information Hardware Configuration Hardware Installation Port Address Range Enabling the Special Registers Interrupt Status RegisterOptions Register Bit Name DescriptionClock Rate Multiplier RR1 RR0Windows Configurations Windows MillenniumWindows Windows Page Using the New Hardware Found Wizard Page Viewing Resources with Device Manager Page Page ESCLP-100 Eight-Port RS-232 Serial Adapter Page Page Page Page Page DOS and other operating systems Windows NTOS/2 Page QTPCI.EXE QTPCI.EXE Expert Mode display External Connections RS-232 INTA# ISL4245EIR Page Computer will not boot up ESCLP-100 Revision December