6.3.1 QTPCI.EXE
Quatech's "QTPCI" utility supplies the information required when modifying the serial port settings of the application. This program should be run from real DOS, not in a Windows DOS box.
Figure 11 shows the Basic Mode display for the ESC(LP)-100 after the "Q" key has been pressed. In this example, the ESC(LP)-100 uses I/O base address FF80 hex and IRQ 11. The hardware revision of the ESC(LP)-100 is also displayed. Pressing the "N" key will show similar information for all non-Quatech PCI devices in the system, including those devices integrated on the motherboard.
The QTPCI program is capable only of displaying the PCI
configuration. It cannot be used to make changes.
Figure 11 --- QTPCI.EXE Basic Mode display
25 |