Quatech DSCLP-100 user manual PCI Resource Map, Inta#

Page 28

8 PCI Resource Map

Listed below are the PCI resources used by the DSCLP-100. Such information may be of use to customers writing their own device drivers or other custom software. A detailed description of the DSCLP-100's UARTs is available on the Quatech web site.

(all numbers in hex)

PCI Vendor ID:

0x135C

Quatech, Inc.

PCI Device ID:0x0180DSCLP-100

PCI Device ID:0x0190SSCLP-100

PCI Class Code
Base class:	0x07	Simple communications controller
Subclass:	0x02	Multiport serial controller
Interface:	0x00
IRQ sourced by:	INTA#
Base address 0:	0x80 bytes Mem	Reserved region
Base address 1:	0x80 bytes I/O	Reserved region
Base address 2:	0x10 bytes I/O	Serial ports(DSCLP-100)
		Port 1 at offset 0x00
		Port 2 at offset 0x08(DSCLP-100)

DSCLP/SSCLP-100 User's Manual

23

Image 28

Contents DSCLP/SSCLP-100 Page Date of Purchase Model Number Declaration of Conformity Table of Contents General Information Hardware Configuration Factory Default ConfigurationEnable Scratchpad Register SPAD, J2 Force High-Speed Uart Clock X2 or X4, J4-J5Clock multiplier jumper options Hardware Installation Jumper/connector locationsThis page intentionally blank Address Map and Special Registers Base Address and Interrupt Level IRQEnabling the Special Registers Interrupt Status RegisterOptions Register Enhanced Serial Adapter IdentificationClock Rate Multiplier RR1 RR0Windows Configurations Windows MillenniumWindows Windows Windows Using the New Hardware Found Wizard Viewing Resources with Device Manager Page Page Page Other Operating Systems Windows NTOS/2 DOS and other operating systemsQTPCI.EXE Basic Mode display QTPCI.EXE Expert Mode display External Connections RS-232 Port Signal PCI Resource Map INTA#Specifications ICL3245CAPage Troubleshooting Computer will not boot upSSCLP/DSCLP-100