Quatech DSCLP-100 user manual Specifications, ICL3245CA

Page 29

9 Specifications

Bus interface:		PCI, 32-bit bus, 5-volt only
		IBM-compatible computers
Dimensions:		approx. 5.0" x 3.7"
Serial ports
Controller:		16550 with 16-byte FIFOs
Interface:		One male D-25 connector
		Two male D-9 connectors
		using adapter cable
Transceivers:		ICL3245CA
High-level output: +5V min
Low-level output: -5V max,
Switching speed
Power requirements
+3.3	volts:	approx. 250 mA
+/-12 volts:		approx. 35 mA
Temperature:		operating 0° to 70°
		storage -50° to 80°
Humidity:		10% to 90%

24	DSCLP/SSCLP-100 User's Manual

Image 29

Contents DSCLP/SSCLP-100 Page Date of Purchase Model Number Declaration of Conformity Table of Contents General Information Factory Default Configuration Hardware ConfigurationEnable Scratchpad Register SPAD, J2 Force High-Speed Uart Clock X2 or X4, J4-J5Clock multiplier jumper options Jumper/connector locations Hardware InstallationThis page intentionally blank Base Address and Interrupt Level IRQ Address Map and Special RegistersInterrupt Status Register Enabling the Special RegistersEnhanced Serial Adapter Identification Options RegisterRR1 RR0 Clock Rate MultiplierWindows Millennium Windows ConfigurationsWindows Windows Windows Using the New Hardware Found Wizard Viewing Resources with Device Manager Page Page Page Windows NT Other Operating SystemsOS/2 DOS and other operating systemsQTPCI.EXE Basic Mode display QTPCI.EXE Expert Mode display External Connections RS-232 Port Signal INTA# PCI Resource MapICL3245CA SpecificationsPage Computer will not boot up TroubleshootingSSCLP/DSCLP-100