Patton electronic 1082, 144, I user manual Warranty Information, FCC Information, CE Notice

Page 4

1.0 WARRANTY INFORMATION

Patton Electronics warrants all Model 1082/I and Model 1082/144/I components to be free from defects, and will—at our option—repair or replace the product should it fail within one year from the first date of shipment.

This warranty is limited to defects in workmanship or materials, and does not cover customer damage, abuse or unauthorized modification. If this product fails or does not perform as warranted, your sole recourse shall be repair or replacement as described above. Under no condition shall Patton Electronics be liable for any damages incurred by the use of this product. These damages include, but are not limited to, the following: lost profits, lost savings and incidental or consequential damages arising from the use of or inability to use this product. Patton Electronics spe- cifically disclaims all other warranties, expressed or implied, and the installation or use of this product shall be deemed an acceptance of these terms by the user.

1.1 FCC INFORMATION

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interfer- ence when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna

Increase the separation between the equipment and receiver

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected

1.2 CE NOTICE

The CE symbol on your Patton Electronics equipment indicates that it is in compliance with the Electromagnetic Compatibility (EMC) directive and the Low Voltage Directive (LVD) of the Union European (EU). A Certificate of Compliance is available by contacting Patton Technical Support.

4

Image 4
Contents User Manual Table of Contents Model 1082/I Factory Replacement Parts Accessories FCC Information Warranty InformationCE Notice Service Tel 301 Mailsupport@patton.comFeatures General InformationDescription 1082 Snmp Management SolutionsHTTP/HTML Management PPP Operational Background ApplicationsEthernet LAN Page Configuration Configuring the Hardware DIP SwitchesConfiguring DIP Switch S1 S1 Summary Table Position Function Factory DefaultSwitches S1-1 and S1-2 Data Rate S1-3 Setting S1-4Switch S1-5 Asynchronous/Sync Operation S1-5 SettingSwitches S1-6 and S1-7 System Clock Mode S1-6 S1-7 Clock Mode DescriptionSwitch S1-8 Response to RDL Request S1-8 SettingS2 Summary Table Position Function Factory Default Configuring DIP switch S2S2-1 Activation Description S2-2 Setting Switch S2-2 Front Panel Switch DisableSwitches S2-3, S2-6, S2-7 and S2-8 Reserved Installation Connecting DSL InterfaceConnecting 10BASE-T Ethernet Port to PC DTE Connecting 10BASE-T Ethernet Port to HUB DCE10Base-T DTE RJ-45 Pin NoPower Connection Universal AC Power 100-240VACDC Power To Power Supply JackOperation POWER-UPLED Status Monitors LED Test Modes Remote Digital Loopback RDL/V.52 BERPage Diagnostics LED Status IndicatorsConnectors PowerTemperature Range DimensionsWeight AltitudeAppendix B Model # Description