Patton electronic 1082, 144, I user manual Installation, Connecting DSL Interface

5.0 INSTALLATION

When the Model 1082 has been properly configured, it may be con- nected to the DSL twisted pair interface, the 10Base-T Ethernet Inter- face, and the power source. This section describes these connections.

Interface connectorDSL interface

ON

PowerOFF O Interface

Made in the USA

DSL

Power input connector

M	d	l	.
Power			G	.
		1194E		703/G
			Single

DSL

511EMade	in
		the
			USA
-
Quad
G.
703/G
.704
	Interface

Figure 6. Model 1082/I or Model 1082/144/I rear view

5.1 CONNECTING DSL INTERFACE

The Model 1082 supports communication between 10Base-T Hubs or Workstations at distances to 5 miles (8 km) over 24 AWG (.5mm) twisted pair wire. There are two requirements for installing the Model 1082:

•These units operate as a pair. Both units at the end of the twisted pair DSL span must be set for the same DTE rate.

•To function properly, the Model 1082 needs one twisted pair of metallic wire. This twisted pair must be unconditioned, dry, metallic wire, between 19 (.9mm) and 26 AWG (.4mm) (the higher number gauges will limit distance). Standard dial-up telephone circuits, or leased cir- cuits that run through signal equalization equipment, or standard, flat modular telephone type cable, are not acceptable.

17