Patton electronic 1082, 144, I user manual General Information, Features

Page 6

2.0 GENERAL INFORMATION

Thank you for your purchase of this Patton Electronics product. This product has been thoroughly inspected and tested and is warranted for One Year parts and labor. If any questions or problems arise during installation or use of this product, please do not hesitate to contact Patton Electronics Technical Support at (301) 975-1007.

2.1 FEATURES

•Provides MAC Level Data Link (Layer 2) connection between two peered 10Base-T Ethernet LANs

•Operates transparently to higher level protocols such as TCP/IP, DEC- net, NETBIOS and IPX

•PPP (Point to Point Protocol, RFC 1661) with Bridge Control Protocol (RFC 1638)

•Automatically learns, loads and removes MAC addresses

•Point-to-point distances up to 5 miles (all data rates) on 24 AWG twisted pair

•HTTP/SNMP Manageable as CP (Customer Premises) Unit with 1092ARC CO (Central Office) Rack Card and 1001MC management card

•Internal or receive recovered clocking between units

•LED indicators for 10Base-T Link, DSL Link, Status, No Signal, Error and Test Mode

•Remote digital loopback, local line loopback diagnostic modes

•Synchronous data rates: 19.2, 32, 56, 64, 128, and 144 kbps

Note 144 kbps data rate is only available on the Model 1082/144/I.

19.2kbps rate is available on all Model 1082 series modems except for the 1082/144/I.

•Full duplex operation over a single twisted pair (2-wires)

•Multi-Rate Symmetric DSL

•Compatible with the popular Patton Model 1092A

•Universal power supply (90–260VAC) or DC power supply (-48VDC)

•Small, Convienent Desktop Unit

•CE Marked

6

Page 5 Page 7
Image 6
Page 5 Page 7
Contents User Manual Table of Contents Model 1082/I Factory Replacement Parts Accessories Warranty Information FCC InformationCE Notice Service Tel 301 Mailsupport@patton.comFeatures General Information1082 Snmp Management Solutions DescriptionHTTP/HTML Management PPP Operational Background ApplicationsEthernet LAN Page Configuration Configuring the Hardware DIP SwitchesConfiguring DIP Switch S1 S1 Summary Table Position Function Factory DefaultSwitch S1-5 Asynchronous/Sync Operation Switches S1-1 and S1-2 Data RateS1-3 Setting S1-4 S1-5 SettingSwitch S1-8 Response to RDL Request Switches S1-6 and S1-7 System Clock ModeS1-6 S1-7 Clock Mode Description S1-8 SettingConfiguring DIP switch S2 S2 Summary Table Position Function Factory DefaultS2-1 Activation Description Switch S2-2 Front Panel Switch Disable S2-2 SettingSwitches S2-3, S2-6, S2-7 and S2-8 Reserved Installation Connecting DSL Interface10Base-T DTE Connecting 10BASE-T Ethernet Port to PC DTEConnecting 10BASE-T Ethernet Port to HUB DCE RJ-45 Pin NoPower Connection Universal AC Power 100-240VACDC Power To Power Supply JackPOWER-UP OperationLED Status Monitors LED Test Modes Remote Digital Loopback RDL/V.52 BERPage Connectors DiagnosticsLED Status Indicators PowerWeight Temperature RangeDimensions AltitudeAppendix B Model # Description
Top Page Image Contents