Patton electronic 2158 user manual Standalone Unit Installation

Page 8

3.0 INSTALLATION

Because the CopperLink Ethernet Extender requires no configuration, it can be installed quickly. If you are installing a standalone unit, refer to section 3.1 “Standalone unit installation”. Otherwise, refer to section 3.2 “Rack card installation”.

Note If asymmetric transmission or line rates other than 12.5 Mbps are required (Model 2168 only), refer to section 4.0, “Configura- tion (Model 2168 Only)” on page 14.

3.1 STANDALONE UNIT INSTALLATION

Do the following:

1.Connect the line interface between the units (refer to section 3.3, “Connecting the Twisted-Pair Line Interface” on page 10)

Note See Figure 2 for the standalone unit’s rear panel arrangements.

2.Connect the Ethernet interface (refer to section 3.4, “Connecting the 10/100Base-T Ethernet Interface” on page 11).

3.Connect the power plug (refer to section 3.5, “Connecting Power” on page 12).

Figure 2. CopperLink Ethernet Extender standalone rear panel

8

Image 8
Contents User Manual Contents Distance Chart, Based on 24 AWG 0.5 MM CopperLink Series Interface Pin AssignmentCE Notice Warranty InformationRadio and TV Interference Service Tel +1 301 Email support@patton.comDescription FeaturesGeneral Information Typical application Installation Standalone Unit InstallationRack Card Installation CopperLink Ethernet Extender rack cardsConnecting the TWISTED-PAIR Line Interface Connecting the 10/100BASE-T Ethernet Interface CopperLink Ethernet Extender twisted pair line interfaceConnecting the 10/100Base-T Ethernet Port to a Hub Connecting the 10/100Base-T Ethernet Port to a PC DTEConnecting Power 10/100Base-T DTEPage Configuration Model 2168 only Configuring the Hardware DIP SwitchesModel 2168 standalone modem DIP switch orientation Configuring DIP Switch S1 Switch S1-1 Ethernet Auto SenseS1-1 Setting Switches S1-2 and S1-4 Data RateS1-2 S1-3 S1-4 Asymmetric Line Rates DS/US S1-5 S1-6 S1-7 S1-8 Reserved for future useFront Panel LED Status Monitors Power UPOperation LED is solid yellow and the CopperLink Link LED LEDDescription Port. The more error corrections, the more often LED Status Indicators Power SupplyAppendix a LAN ConnectionHumidity Temperature RangeDimensions Appendix B Patton Model # DescriptionAppendix C Appendix D 10/100BASE-T InterfaceRJ-45 Copperlink InterfaceAsymm Line Rate DS/US Distance in feet km Appendix ESymm Line Rate DS/US Distance in feet km Page Copyright Patton Electronics Company All Rights Reserved