Patton electronic 1095 Configuring the Hardware DIP Switches, Configuration DIP Switch Set S2

3.0 CONFIGURATION

The Model 1095 is equipped with three sets of eight DIP switches, which allow configuration of the unit for a wide variety of applications. This section describes switch locations and explains all possible config- urations.

3.1 CONFIGURING THE HARDWARE DIP SWITCHES

The 24 external switches are grouped into three eight-switch sets, and are externally accessible from the underside of the Model 1095 (See Figure 1).

On

S3

Back		Front
	S2

3.1.2 Configuration DIP Switch Set “S2”

The configuration switches on S2 allow you to specify the Clocking Mode and response to DTE Loop Enable. Default settings of S2 are shown in the table below.

S2 SUMMARY TABLE

Position	Function		Factory Default
S2-1	Reserved			Off
S2-2	Reserved			Off
S2-3	Reserved			Off
S2-4	Reserved			Off
S2-5	Reserved			Off
S2-6	Clock Mode	On		Receive
S2-7	Clock Mode	Off		Recovered Clock
S2-8	Enable Loop from DTE	Off		Disable

Switch S2-1, S2-2, S2-3, S2-4, and S-5: Reserved for future use and

should remain in the Off position.

Off

S1

Figure 1. Underside of Model 1095, Showing Location of DIP Switches

3.1.1 Configuration DIP Switch Set “S1”

All switches in Switch Set S1 are reserved for future use. These switches must remain in the ON position (See Figure 2).

ON ON

1 2 3 4 5 6 7 8 OFF

Figure 2. Close Up of Configuration Switches (all sets are identical in appearance)

5 6