Patton electronic 12168 user manual Connecting the 10/100BASE-T Ethernet Interface

The terminal block connector on the Model 1068's twisted pair interface is polarity insensitive and is wired for a two-wire interface. The signal/pin relationships is shown in Figure 5.

USA

in	the
Made

Power

VLINK

Ethernet

RING TIP

Figure 5. Model 1068D (Terminal Block) twisted pair line interface.

3.4 CONNECTING THE 10/100BASE-T ETHERNET INTERFACE

The shielded RJ-45 port labeled Ethernet is the 10/100Base-T interface. This port is designed to connect directly to a 10/100Base-T network. Figure 6 shows the signal/pin relationships on this interface. You may connect this port to another Ethernet device via a Type 4 or Type 5 cable that is up to 328 ft long.

1

2

3

4

5

6

7

8

1 TX+ (data output from 1068)

2 TX- (data output from 1068)

3 RX+ (data input to 1068)

4 (no connection)

5 (no connection)

6 RX- (data input to 1068)

7 (no connection)

8 (no connection)

Figure 6. Model 1068 10/100Base-T RJ-45 Connector Pinout.

12