3.2 RACK CARD INSTALLATION
The Model 1068 rack card version comprises a front card and a rear card.Do the following to install the cards into the rack chassis:
1.Slide the rear card into the back of the chassis along the metal rails.
2.Secure the rear card using the supplied metal screws.
3.Slide the front card into the chassis until you feel resistance as the front card engages the rear card. When that happens, gently push the front card forward until it is fully seated in the
4.Secure the front card using the captive fasteners.
Note The Model 1001R14 chassis supports “hot swapping” of cards, so it is not necessary to power down the rack when you install or remove a Model 1068 rack card.
VLINK
VLINK
terminal block
Ethernet
Port
|
| VLINK |
|
| |
|
| VLINK |
| VLINK | terminal block |
|
| |
VLINK | POTS/ISDN | Port |
|
| POTS/ISDN |
|
| Port |
|
| Ethernet |
| Ethernet |
|
Ethernet | 1068DVRC |
|
|
|
1068DRC
Figure 3. Model 1068 rack cards
5.Connect the line interface between the units (refer to section 3.3, “Connecting the
Note See Figure 3 for the rack card’s panel arrangements.
10