Patton electronic 12168 user manual Configuration, Configuring the Hardware DIP Switches

Page 15

4.0 CONFIGURATION

The Model 1068 has four DIP switches for conﬁguring the unit for a wide variety of applications. This section describes switch locations and explains the different conﬁgurations.

4.1 CONFIGURING THE HARDWARE DIP SWITCHES

Using a small ﬂat-tip screwdriver, remove the protective cover located on the underside of the Model 1068 (see Figure 10).

Power

Link

	QOL
Link	VLINK

Activity

Ethernet

VLINK

Modem

Figure 10. Removing protective cover

Figure 11 and Figure 12 on page 16 show the orientation of the DIP switches in the On and Off positions.

15

Image 15

Contents User Manual Contents Distance CHART, Based on 24 AWG 0.5 MM Warranty Information Radio and TV InterferenceCE Notice Page Tel +1 301 Email support@patton.com Industry Canada Notice ServiceFeatures General InformationDescription Typical application Installation Standalone Unit Installation1068DV 1068DVRC 1068DRC Rack Card InstallationModel 1068 RJ-45 twisted pair line interface Connecting the TWISTED-PAIR Line InterfaceModel 1068D Terminal Block twisted pair line interface Connecting the 10/100BASE-T Ethernet Interface1068 10/100Base-T Port 10/100Base-T Hub RJ-45 Pin No Connecting the 10/100Base-T Ethernet Port to a HubConnecting the 10/100Base-T Ethernet Port to a PC DTE Connecting the POTS/ISDN LineModel 1068DV RJ-45 POTS/ISDN interface Connecting PowerConfiguring the Hardware DIP Switches ConfigurationSwitch toggle Configuring DIP Switch S1 Asymmetric Line Rates DS/US S1-2Power UP OperationFront Panel LED Status Monitors Description LEDDimensions LED Status IndicatorsPower Supply Temperature RangePatton Model # Description Appendix BPOTS/ISDN Interface Appendix C10/100BASE-T Interface Vdsl InterfaceAppendix D Symm Line Rate DS/US Distance in feet kmAsymm Line Rate DS/US Distance in feet km