Patton electronic Model 1058 Installation, 1058DV, Connecting the TWISTED-PAIR Line Interface

3.0 INSTALLATION

Because the Model 1058 requires no configuration, it can be installed and made operational quickly. Installation takes place as follows:

1.Connecting the line interface between the units (refer to section 3.1, “Connecting the Twisted-Pair Line Interface” on page 7)

Note See Figure 2 for the rear panel arrangements.

2.Connecing the Ethernet interface (refer to section 3.2, “Connecting the 10/100Base-T Ethernet Interface” on page 9).

3.Connecting the power plug (refer to section 3.4, “Connecting Power” on page 11).

1058DV

1058D

US A

		in	the
Ma	de

Power

Link

VDSL

Ethernet

VDSL twisted-pair

Ethernet RJ-45 interface port

VDSL twisted-pair

terminal block

interface

		US	A
	in	the
Ma	de

	Power
	Link
	VDSL
	POTS/ISDN
Ethernet	Power
	jack

POTS/ISDN twisted-pair terminal block interface

Figure 2. Model 1058 standalone rear panel

3.1 CONNECTING THE TWISTED-PAIR LINE INTERFACE

The Model 1058 supports communication between two peer Ethernet LAN sites over a distance of up to 4,652 ft (1,418 m) over 24 AWG (0.5 mm) twisted-pair wire.

Note Actual distance and link performance may vary depending on the environment and type/guage of wire used.

7