Patton electronic Model 1058 user manual Connecting the 10/100BASE-T Ethernet Interface

USA

in	the
Made

e	r
ow
P

k

		L	Lin
V	D	S

rn et

E the

RING TIP

Figure 4. Model 1058D (Terminal Block) twisted pair line interface.

3.2 CONNECTING THE 10/100BASE-T ETHERNET INTERFACE

The shielded RJ-45 port labeled Ethernet is the 10/100Base-T interface. This port is designed to connect directly to a 10/100Base-T network. Figure 5 shows the signal/pin relationships on this interface. You may connect this port to another Ethernet device via a Type 4 or Type 5 cable that is up to 328 ft long.

1

2

3

4

5

6

7

8

1 TX+ (data output from 1058)

2 TX- (data output from 1058)

3 RX+ (data input to 1058)

4 (no connection)

5 (no connection)

6 RX- (data input to 1058)

7 (no connection)

8 (no connection)

Figure 5. Model 1058 10/100Base-T RJ-45 Connector Pinout.

Connecting the 10/100Base-T Ethernet Port to a Hub

The Model 1058 10/100Base-T interface is configured as DTE (Data Ter- minal Equipment), just like a 10/100Base-T network interface card in a PC. Therefore, it "expects" to connect to a 10/100Base-T Hub using a

9