Patton electronic user manual Model 1058 RJ-45 twisted pair line interface

Follow the steps below to connect the Model 1058 VDSL Interfaces.

Note The Model 1058 units work in pairs. One of the units must be a Model 1058/CO (Central Office), and the other unit must be a Model 1058/CP (Customer Premise). It does not matter which end is the 1058/CO and which is the 1058/CP. The link is always initiated by the 1058/CP. As long as the 1058/CO is powered on, the 1058/CP can establish a link by being powered on or by hav- ing its power reset.

1.To function properly, the two Model 1058's must be connected together using twisted-pair, unconditioned, dry, metal wire, between 19 (0.9mm) and 26 AWG (0.4mm). Leased circuits that run through signal equalization equipment are not acceptable.

2.The Model 1058 is equipped with two interface jacks that can be used on the VDSL interface, an RJ-45 or a terminal block. These VDSL interfaces are a two-wire interface. Observe the signal/pin relation- ships on the Model 1058's VDSL interface jacks.

The RJ-45 connector on the Model 1058's twisted pair interface is polar- ity insensitive and is wired for a two-wire interface. The signal/pin rela- tionship is shown in Figure 3.

	1	(no connection)
1	2 (no connection)
2	3 (no connection)
3
	4	(2-Wire RING)
4
5	5	(2-Wire TIP)
6	6 (no connection)
7
	7 (no connection)
8

8 (no connection)

Figure 3. Model 1058 (RJ-45) twisted pair line interface.

The terminal block connector on the Model 1058's twisted pair interface is polarity insensitive and is wired for a two-wire interface. The signal/pin relationships is shown in Figure 4.

8