straight-through RJ-45 cable. Figure 6 diagrams the cable wiring for con- necting the Model 1058 to a 10/100Base-T hub.
1058 10/100Base-T Port | 10/100Base-T Hub |
RJ-45 Pin No. | RJ-45 Pin No. |
1 | (TX+)-------------------------------------------------- | 1 (RX+) |
2 | (TX-)--------------------------------------------------- | 2 (RX-) |
3 | (RX+)-------------------------------------------------- | 3 (TX+) |
6 | (RX-)--------------------------------------------------- | 6 (TX-) |
Figure 6. Wiring diagram for connecting the Model 1058 to a 10/100Base-Thub
Connecting the 10/100Base-T Ethernet Port to a PC (DTE)
The Model 1058 10/100Base-T interface is configured as DTE (Data Ter- minal Equipment). If you wish to connect the 1058 to another DTE devices such as 10/100Base-T network interface card in a PC (or 1058s in a back-to-back arrangement), you must construct a 10/100Base-T crossover cable as shown in Figure 7.
1058 10/100Base-T Port | 10/100Base-T DTE |
RJ-45 Pin No. | RJ-45 Pin No. |
1 | (TX+) | 1 (TX+) |
2 | (TX-) | 2 (TX-) |
3 | (RX+) | 3 (RX+) |
6 | (RX-) | 6 (RX-) |
Figure 7. 10/100Base-T crossover cable
3.3 CONNECTING THE POTS/ISDN LINE
The RJ-45 port labeled “POTS/ISDN” is the POTS/ISDN interface. A tele- phone or an ISDN device may be connected to this port and carried over the VDSL line. The units do not need power for the POTS interface to