Roland KF-7 Before You Start Playing, Installing the Music Stand, Connect the Power Cord

Before You Start Playing

Before You Start Playing

Installing the Music Stand

fig.00-03.j

1.Using the supplied screws, attach the music stand to the back of the KF-7 as illustrated.

Be sure to use the supplied screws for attaching the music stand.

Turn the screws clockwise until they’re held in place–but don’t tighten them yet.

2.Put the music stand between the screws and the KF-7’s body.

3.While supporting the music stand with one hand, secure it in place by turning the screws.

*When attaching the music stand, support it firmly with one hand to make sure that you don’t drop it. Be careful, so you don’t get your fingers pinched.

*Do not apply excessive force to the installed music stand.

4.To remove the music stand, support it with one hand while loosening the screws.

*After removing the music stand, don’t forget to retighten the screws.

Connect the Power Cord

924

* To prevent the inadvertent disruption of power to your unit (should the plug be pulled out accidentally), and to avoid applying undue stress to the AC adaptor jack, anchor the power cord using the cord hook, as shown in the illustration.

Cord Hook

The cord of

the supplied AC Adaptor

To the AC Outlet

Connecting Pedals

925

* Use only the specified expression pedal (EV-5; sold separately). By connecting any other expression pedals, you risk causing malfunction and/or damage to the unit.

1.Connect the supplied pedals (DP-8) to one of the

pedal jacks.

fig.00-03.j

Expression Pedal (EV-5)

Pedal Switch (DP-8)

When connected to the Damper jack, the pedal can be used as a damper pedal.

When connected to Sostenuto, the pedal can be used as a sostenuto pedal.

When connected to Soft, the pedal can be used as a soft pedal.

*Unplugging a pedal cord from the unit while the power is on may cause the pedal’s effect to be applied without stopping. Be sure to switch off the power to the unit before attempting to disconnect or connect a pedal cord.

DP-8

The DP-8 pedal controls the half damper function, a must for authentic piano performances. Switching the DP-8’s function switch to “Continuous” allows you to perform using the half damper function.

Damper Pedal jack of the KF-7

Pedal Cord

Half Damper

Pedal

Switch Control

16