Roland KF-7 owner manual Changing the Recording Method Rec Mode, 116

Chapter 6 Creating and Editing Songs

Chapter 6

❍Step 2 Start Recording

If necessary, choose a recording method.

For more on how to record, refer to p. 116.

If you record for the first time, there’s no need to select the recording method.

Selecting the Part to Record

1.Display the 16-track Sequencer screen (p. 113).

2.Touch the number for the Part you want to record. The Part you touch appears in reverse video.

You can only record drum sounds or effect sounds on Part D (10) or Part S (11). You can select drum sets or effect sounds by selecting Part D (10) or Part S (11) and touching <Drum Set>.

Selecting the sound to play

3.Use the Tone buttons to choose a Tone to play. After selecting a Tone, touch <Exit> to call up the “16- Track Sequencer screen.”

Recording the performance

4.Press the [ (Reset)] button.

Recording will start at the beginning of the song. If you want to record from a point other than the

beginning, use the [ (Bwd)] and [ (Fwd)] buttons to select another measure to begin.

5.Press the [ (Rec)] button and watch the indicator is light up.

The KF-7 is put in recording standby.

6.Press the [ (Play/Stop)] button.

A two-bar count-in sounds, then recording starts.

*You cannot use the performance pads when recording with the 16-track sequencer.

Changing the Recording Method (Rec Mode)

You can use any of the four methods below to record with the KF-7.

Although you will normally be using “Replace Recording,” where previously recorded material is erased when new sounds are recorded, you’ll find that you can record songs easily by using this method in combination with other recording methods.

Replace Recording (p. 117)

This is the normal method for recording. New material is recorded as previously recorded material is erased.

Mix Recording (p. 117)

New notes are recorded on top of notes previously recorded.

This convenient feature makes it easy for you to record melodies over prerecorded accompaniment.

Loop Recording (p. 118)

Specified measures are recorded repeatedly, while new notes are combined with existing music. A convenient feature for creating rhythm parts. Loop Recording allows you to record over and over within a selected segment, adding a different percussion sound with each pass.

Punch-in Recording (p. 119)

You can re-record only a specified passage as you listen to a recorded performance.

→Immediately after the power is turned on, Replace Recording is selected.

7.Press the [ (Play/Stop)] button. Recording stops.

When one part is recorded, continue by selecting and recording another part. Continue layering parts to finish recording the song.

→You only need to follow the procedure described in “Step 1 – Prepare for Recording” when you’re recording the first Part. For the second Part and after, you can skip step 1 and proceed from “Step 2 Start Recording.”

*Any performance that has been recorded is deleted when the power to the KF-7 is turned off. It is a good idea to save song data to a floppy disk or user memory. For more information, refer to “Saving Songs” (p. 101).

116